SHOW SIDEBAR

Please read, understand, and follow the safety and handling precautions in the enclosed manual before using our 2.5 Ton rosin heat press.

Recommended Plant Material Amount for the VE2.5 press:

- Up to 10 grams

Recommended Accessories:

Accessory Options
Pre-Press Mold 2" x 4"
30 mm Cylinder
Filter Bags 2" x 4" (25, 100, 160 micron options)
2.5" x 4.5" (25, 100, 160 micron options)
2" x 5" (25, 100, 160 micron options)
2" x 4" Mixed Mesh Set
2" x 200" Filter Tube (25, 100, 160 micron options)
Parchment Paper 10" x 7" unbleached, pre-cut, 50 sheets per set
10" x 7" bleached, pre-cut, 50 sheets per set
12" x 14" bleached, pre-cut, 50 sheets per set
Tool set 6-Piece tool set
7-Piece tool set
Scraper tool set
Cold Plate 6" x 4" Cold Plate

- Humidity packs;
- Glass stamp, etc.

Press Preparation:

1. Position your press on a sturdy table surface. Note: this machine can be used in both vertical and horizontal orientation, so make sure you have ample space if you plan on using its Driptek function.

2. Connect the press to an electric outlet (110 V / 220 V) and flip the power switch on the top to turn it on.

Operation:

1. Program both control panels to enter a desired plate temperature (s) in Fahrenheit for your operation. Please refer to the press manual for detailed instructions and visual guides. Our general recommendation would be to set up temperature somewhere in the range of 165 °F - 195 °F for fine plant material such as hash, kief, and dry sift or 190 °F - 225 °F for flower. Please keep in mind that low temperature settings yield better quality product at expense of quantity. Once the control panel is set, the heating starts.

2. Wait for the plates to reach the set temperature(s). Tip: the heating icons will be turned off once it's done.

3. Position your material in the center of the bottom plate. Use the side clips to secure it in place if necessary.

4. Push Down button to lower the upper plate and apply pressure. Tip: You can gently press and release the button to achieve gradual press effect.

5. If using Driptek, grasp the handles and lower the machine into the horizontal position.

6.  When extraction is done, press Up button to release the plates. 

7. Remove your pressed material using tools or heat resistant gloves.

8. Turn off the press by flipping the switch when done using the machine.

9. Gather your freshly pressed rosin using collection tools.